ProcedureĬlick Configuration > Radio Configurations > RRM. Configuring CHD for RF Tag Profile (GUI)Ĭonfiguring Coverage Hole Detection (GUI)įollow the procedure given below to configure client accounting.Configuring Coverage Hole Detection (CLI).Configuring Coverage Hole Detection (GUI).To a power level because increasing their downstream transmit power might increase interference in the network. The device does not mitigate coverage holes caused by clients that are unable to increase their transmit power or are statically set For coverage holes that can be corrected, the device mitigates the coverage hole by increasing the transmit power level for that specific access point. The device discriminates between coverage holes that can and cannot be corrected. The alert indicates the existence of an area where clients are continually experiencing poor signal coverage, without havingĪ viable access point to which to roam. Packets, and number of failed packets) lower than those specified in the RRM configuration, the access point sends a “coverage If clients on a lightweight access point are detected at threshold levels (RSSI, failed client count, percentage of failed This feature can alert you to the need for an additional (or relocated) lightweight access point. The RRM coverage hole detection algorithm can detect areas of radio coverage in a wireless LAN that are below the level neededįor robust radio performance. Authentication and Authorization Between Multiple RADIUS Servers.Enabling Syslog Messages in Access Points and Controller for Syslog Server.Predownloading an Image to an Access Point.Cisco Connected Mobile Experiences Cloud.Unscheduled Automatic Power Save Delivery.802.11 Parameters for Cisco Access Points.Converting Autonomous Access Points to Lightweight Mode.Overview of Cisco 9800 Series Wireless Controllers.

Rssi 67